Cincinnati 84 Hypro Vertical Boring Mill

 

The Ways are not scored nor deep grooves. We asked them to wipe down the ways
so that we can see what the ways look like under all that oil / grease.

10601_23Front on shot of the machine
10601_22

This 84″ Hypro is equipped with a fully functioning Side head. Great option, hard to find !10601_20 10601_17

Both of the ram heads swiverl approx 60 degrees. There is also a pendant
Control as you can see on the machine.

10601_13Here is an overall shot of the machine, this is a FLUSH MOUNT machine that requires no PIT

10601_11As you can see again, it has STILL the original belt cover with original paint.  nice !

10601_9

another shot of it10601_5 10601_4 10601_2Here is a shot of the chuck. This 84″ Cincinnati Hypro does NOT come with the fixture that is attached to the chuck. The original chuck is sitting below this fixture. This machine has not been used too much but taken great care of.

 

84″ Cincinnati Hypro Vertical Boring Mill
Cincinnati Hypro

84″ Chuck

Swing……………………………..89″
Height Under Rail………………74″
Feeds………………………………. .010 to .800 IPR
Vert Travel of Rail Hd Rams…. 42″
Vert Travel of Side Head………… 63″
Swivel of Rail Heads……………… +/- 60 Degrees
Table Speeds………………………… 1.1 – 43 RPM (16 Speeds)
Machine Dims………………………….. 188″ x 152″ x 159″
Weight……………………………………..Approx 82,000 Lbs

Excellent Condition 84″ Cincinnati Hypro Vertical Boring Mill

(2) Ram Heads, both swivel
(1) Side Head
Digital Readouts
84″  Chuck
Flush Mount Machine
Pendant Control
This machine has been taken excellent care of and some parts were replaced
to make this machine in excellent running condition. It has had excellent maintanence
throughout it’s life as you can see by the photos. that is ORIGINAL PAINT and there
is flaking still on the ways. Everything works on this machine, It is equipped witih
2 RAM Heads and 1 Side Head and DRO’s
INFORMATION ABOUT A VERTICAL BORING MILL
A Vertical Boring Mill, like this 84″ Cincinnati Hypro (vertical lathe) works much like an engine lathe turned up on and end. You can prefor practically all the typical lathe operations on a vertical turret lathe, including turning , facing, boring , machining  tapers and cutting internal and external threads.  A HORIZONTAL boring mill can be used for many kinds of shopwork such as facing, boring , drilling, and milling. In Horizontal boring mill work, the setup of the work, as well as the setting of the tools is similar to that found in lathe and milling machine work.
As with ANY shop equipment you must observe all posted safety precautions.
The characteristic features of the vertical turret, again, like this 84″ Cincinnati Hypro or Giddings & Lewis 84″ Hypro  lathe are (1) a horizontal table or faceplate that holds the work and rotates about a vertical axis; (2) a side head that can be fed either horizontally or vertically; and (3) a turret slide, mounted on a crossrail that can feed nonrotating tools either vertically or horizontally. Figures 8-1 and 8-2 show vertical turret lathes similar to those generally found in repair ships and shore repair facilities. The main advantage of the vertical turret lathe over the engine lathe is that heavy or awkward parts are easier to set up on the vertical turret lathe and, generally, the vertical turret lathe will handle much larger workpieces than the engine lathe.